529, "The OS you selected is not compatible with the partition(s) on the current boot drive. Disk Manager can partition and format your new drive with the FAT file system but no files can be copied from this version of Disk Manager. It is recommended that you use Disk Manager for Windows to setup your new drive...Do you wish to Continue?"
530, "There are two different types of jumper blocks, identify the one your drive has and make note of the different jumper settings. A custom manual will be created at the end of this tutorial that will indicate whether you need to jumper the drive as Master, Slave, or Cable Select. Click 'Help' for more information on how to jumper your hard drive."
531, "A jumper is a small plastic piece that slides over a pair of configuration pins. The next step in the installation process is to set the jumpers on the back of your head drive so your system can identify the hard drive.\n\nThe following definitions describe the jumper settings:\n\nSingle: This setting should be used if your Western Digital drive is the only drive on the cable. The hard drive should be connected to the black connector at the end of the ATA cable \n\nMaster: This setting can be used if you will be using the new hard drive as a primary master boot drive or a secondary master additional storage drive. The hard drive should be connected to the black connector at the end of the ATA cable. "
532, "\n\nSlave: The setting can be used if you will be using the new hard drive for additional storage only and is not typically used for boot devices on Windows-based system. The hard drive should be connected to the gray (middle) connector on the ATA cable."
533, "Setting the Jumpers"
534, "Backup / Restore MBR - "
535, " "
536, "You can access all Disk Manager controls using only the keyboard.\n\nUse the Tab key to switch between controls, ie buttons, check boxes, list boxes, tab controls.\n\nUse the arrow keys to select items in a list or to switch between tabs in a tab control.\n\nItems in a list can be selected using the spacebar/enter keys.\n\nYou can quickly select certain controls by using a hot key. This is done by pressing the Alt key followed by a letter. The letter assigned to a selection will be underlined in that item's description. Alt-N and Alt-B are assigned to the 'Next' and 'Back' buttons."
537, "Keyboard Navigation"
538, "."
539, "."
540, "Please verify that the Disk Manager CD and/or floppy is in the system and exit Disk Manager to reboot."
541, "File Copying Errors"
542, "If an error occurs copying files to a drive, run ScanDisk and Defrag on the source drive and try again."
543, "\nPlease refer to the \"File Copying Errors\" section of help for more information."
